View Single Post
Unread 02-21-2019, 12:41 PM   #61
Imo000
User
 
Join Date: Jan 2010
Location: Cambridge, Ontario
Posts: 93
Thanks: 0
Thanked 8 Times in 8 Posts
Imo000 is on a distinguished road
Default

With the new tensioner pad in place I've started cleaning half the block in order to get it ready for the installation of the crank carrier. Took the block half to a local car was and power washed all the internal passages, then covered the block with WD40 to drive way the moisture and then a few days later started cleaning it in more detail. After this, I've realized that the connecting rods that Iv'e installed 4 years ago were on the wrong side of the crank carrier. So off they came and were re installed and re oriented on the opposite side. Going to torque them down in the next couple of days. Then the plan is to install the pistons on them and then lower the empty part of the crank carrier into the block half.
Attached Images
File Type: jpg 21.jpg (263.4 KB, 0 views)
File Type: jpg 22.jpg (249.0 KB, 0 views)
File Type: jpg 23.jpg (250.4 KB, 0 views)
File Type: jpg 24.jpg (258.3 KB, 0 views)
Imo000 is offline   Reply With Quote
The Following User Says Thank You to Imo000 For Your Post:
carlege (02-21-2019)