View Single Post
Unread 06-04-2009, 08:19 AM   #7
Constantine
User
 
Constantine's Avatar
 
Join Date: Dec 2008
Posts: 32
Thanks: 0
Thanked 7 Times in 4 Posts
Constantine is on a distinguished road
Default

Quote:
Originally Posted by Mike Frye View Post
Constantine,

How difficult is removing the TT compared to, say, removing the transmission?

I've done the entire clutch job and also had my trans out to replace the springs in there, but the TT has never been out.

Can the TT be removed by sliding the trans back like I had to do to remove my clutch or does the trans have to come completely out again?
Hi Mike,

From what others have said, the TT can be removed from a 5 speed without having to remove the trans. As you described, the trans can be slid back a bit to allow room to get the TT out. This is possible with the 5 speed TT since the drive shaft does not stick out from the TT much on either end, unlike the auto TT.

HTH!
__________________
Constantine
Black Sea R&D
772-713-1289
928 Torque Tube (TT) Super Bearings -Rebuild your own TT to better than new specs!
928 Front Flexplate Super Clamp -Save your engine from thrust bearing failure, for all 928 automatics!
924/944/968 TT Super Bearings -Now available!

Constantine is offline   Reply With Quote