I had a few minutes this evening to install Ken's PorKultch'r
:
- Remove 2 13mm bolts and plate
- S4's have spacers under the stock plate, retain these. Not sure of pre/post S4's
- Undo circlip and washer on the clutch rod and the pedal and remove rod
- Be careful of the clutch pedal with the clutch assist spring..basically it's a great finger cracker w/o the clutch rod
- Fit the new bracket with spacer, bolts and washers. I started with 1 cm of adjustment. Use a small 10mm wrench (spanner) to tighten the stop nut once desired stop is achieved.
- Tighten to 17 ft/lbs and reconnect clutch rod
Done
8 minutes total. Will post up more on driving tomorrow.