06-30-2015, 08:52 PM
|
#43
|
User
Join Date: Jan 2010
Location: Cambridge, Ontario
Posts: 93
Thanks: 0
Thanked 8 Times in 8 Posts
|
Last night noticed the connecting rods and pistons were upside down. Tonight I spun them around. Last night the con rod bolts were only finger tight so I put a note on it. Once I spun them around I torqued the ARP bolts to 45ft/lb and then removed the pistons as they need to be off to put the case halves back together. I've also measured the crankshaft endplay and it was "0.005 or 0.127mm. The new installation limit is 0.05mm to 0.24mm. The wear limit is 0.28mm. I'm at the middle of the new installation limits.
|
|
|