Vehicle #2 Information - OR - Vehicle #1 Engine and Modifications
Maintenance since purchase:
-Complete interior detail, including new neoprene mats (thanks Rob Budd), 930 steering wheel, GTS shifter, fixed/replaced a bunch of loose bits, lots of Lexol.
-Rear hatch latch and hatch shocks
-Fuel, air & smog filter
-PDR on rear quarter (Dent Wizard works miracles)
-Shift coupler, rear (Front ball cup was done by PO)
-Clutch master, new
-Brake master, blue hose, and clutch master replace (again, because I ripped 1 of the seals)
-SST brake lines and Super Blue
-O2 sensor
-Motor mounts (no OPG because it had just been done by PO)
-18" Turbos, w/ BFGoodrich G-forge A/S
-Short shifter
-Rubber fuel lines (Thanks Roger)
-Transaxle lube (Redline 75-90)
-Paul Champagne door inserts (black Pascha, white piping)
-TB/WP/OP R&R (w/Porkension'r and 32v cam timing tool)
-Coolant bridge & oil filler neck seal replace, and Tstat (83deg.)
-Hall & Crank sensor connector replace (the Hall was disconnected setting ign. back 6 degrees)
-1" Wheel spacers, studded (Removed because wheels didn't fit)
-RMB
-PS system refresh w/ new hoses, clean & flush
-Coolant hoses, accessory belts
-Steering rack w/ new boots (only 15K on the tie rods)
-Engine lube (Mobile1 15-50, sorry Kibort... had to switch back)
-G05 coolant and flush
-Ott links, front & poly sway bar bushings
-flex-line & hard lines, clutch master to slave
-Clutch slave, new
-Clear front turn signal lenses and sidemarkers (Thanks Nicole)
-Alternator cooling hose
-Hood insulation & shocks
-Shave front wheel bearing caps (for Turbo wheel fitment), repack wheel bearings
-New front belly pan
-New/Used H5 headlamp (Thanks 928 International for 50% off)
-New/Used seat memory controller (Thanks 928 International for 50% off)
-Analog clock, late model
-Wheel alignment
-Tranny mounts
-Clutch kit w/ GTS pressure plate & RMS
-Ride height adjustment & another alignment
-Install GTS mirrors, painted to match
-18" Carrera III's w/ Bridgestone RE50 Pole Positions (summer tires)
-Install rear spoiler, painted to match
-Replace fuel breather Y-pipe (got the part, thanks Worf)
-Replaced charcoal cannister - accidentally broke the old one
-Fix intermittent right window - replaced window motor
-Fuel tank R&R - new pump, new rubber, fuel level sender, strainer
-Install new Koni's all around (Thanks Gary)